Work Stuff Bucket Detailing Brush Holder

Description

IMPORTANT – HOLDER ONLY. This listing is for the 3D-printed holder described below, in the quantity and options selected. Brushes, bottles, polishers, pressure-washer equipment and other items shown in use are NOT INCLUDED. Supply your own equipment.

INDEPENDENT ACCESSORY – NOT AN OFFICIAL WORK STUFF ACCESSORY. Brand and model names identify equipment this Layered Works item is intended to fit or hold. Work Stuff did not make, approve or endorse it. Check your exact model, dimensions and fit before use. Do not force a fit or overload the item. We cannot accept responsibility for damage caused by incorrect fit, installation, overloading or misuse where our accessory and description are not at fault. Your statutory rights remain unaffected if our accessory is faulty or misdescribed.

Work Stuff Bucket Detailing Brush Holder

A functional bucket rim holder designed to store two detailing brushes. Keeps brushes within easy reach during work, prevents them from falling into the water or touching the ground.

Key benefits

• Purpose-built for an organised detailing setup
• Printed to order in durable PETG
• Available in Black, Red, White or Grey

Compatibility & fitment

Check the stated dimensions and compare your item with every listing photograph before ordering. Similar-looking equipment can differ, so the buyer is responsible for confirming fitment.

What is included

The selected printed PETG item or set only. Tools, batteries, polishers, brushes, pads, wall fixings and other photographed accessories are not included.

3D-printed finish

This made-to-order FDM print will show fine layer lines, seam marks and small surface variations. These are normal and do not affect normal use. Colours can vary slightly between filament batches and screens.

Design attribution: Design by vlodek2532 on MAKERWORLD. Commercially licensed for production by Layered Works.